JET 710116K Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 16)

Adjusting Blade Tracking

Disconnect machine from the

power source! Never adjust blade tracking with the

machine running!

Failure to comply may cause serious injury!

“Tracking” refers to how the blade is situated upon the

wheels while in motion. The blade should track in the

center of both wheels.

1. The blade must be properly tensioned before

adjusting blade tracking. The release lever should

be in the down (tensioned) position. Make sure

blade guides and blade bearings do not interfere

with the blade.

2. Open top blade cover. Rotate the wheel forward

and observe the position of the blade on the wheel

- it should be in the center of the wheel. See Fig. 9.

3. If adjustment is necessary, loosen wing nut (Fig. 7),

and tighten tracking knob slightly to move blade

toward rear of machine. Slightly loosening the

tracking knob will cause the blade to track toward

the front of the machine.

4. Tighten wing nut after blade is tracking in the

center of the wheel.

Adjusting Upper Blade Guide

Assembly

Blade guard has been removed for

picture clarity. Never operate the bandsaw without

all guards in place and in working order!

Failure to comply may cause serious injury!

1. Disconnect machine from the power source.

2. Loosen lock knob (C, Fig. 10) and raise or lower

upper blade guide assembly (B, Fig. 10) by turning

knob (A, Fig. 10) to just above the material being

cut.

3. Tighten lock knob. Make sure blade guide

bearings (D, Fig. 10) are still aligned next to the

blade. If adjustment is necessary, review

“Adjusting Upper Blade Guides and Thrust

Bearings” section of manual.

Figure 9

Figure 10

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Keine Kommentare

JET 710116K Gebrauchs- und Pflegehandbuch Seite 16