JET 710116K Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 18)

Adjusting Lower Blade Guides and

Thrust Bearings

Table Removed For Clarity. Never

operate the bandsaw without a table secured in

place.

1. Disconnect machine from the power source.

2. Blade must already be tensioned and tracking

properly.

3. Loosen thumb screw (G, Fig. 12) and turn knurled

knob (F, Fig. 12) to move the thrust bearing (H, Fig.

12) in or out until the bearing is 1/64" behind the

blade.

4. Tighten thumb screw (G, Fig. 12).

5. Loosen thumb screw (D, Fig. 12) and turn knurled

knob (E, Fig. 12) to move the guide block bracket in

or out until the front edge of the guide bearings are

just behind the "gullets" of the saw teeth.

6. Tighten thumb screw (D, Fig. 12).

7. Loosen lock bolt (C, Fig. 12) and rotate guide

bearings (B, Fig. 12) using cam (A, Fig 12) with

provided 4mm hex wrench as close to blade as

possible without pinching it.

8. Tighten lock bolt (C, Fig. 12).

Adjusting Guide Post Parallel To

Blade

1. Verify guide post is parallel to blade by checking

position of bearings with respect to blade when the

guide post is raised all the way up and again in the

lowest position.

2. If the bearings have shifted throughout the travel of

the guide post then it needs to be adjusted.

3. If adjustment needs to be made left and right,

slightly loosen the four bolts (A, Fig 12a) and make

slight guide post adjustments as needed. Tighten

bolts when completed.

4. If adjustment needs to be made forward and aft,

adjustment is made by tightening and loosening the

set screws (B, C, Fig 12a). The top set screws (B,

Fig 12a) adjust the guide post back (when standing

in front of saw), while the bottom set screws (C, Fig

12a) will adjust the guide post forward.

Figure 12

Figure 12a

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

JET 710116K Gebrauchs- und Pflegehandbuch Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge JET 710116K