JET 710116K Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 17)

Adjusting Upper Blade Guides and

Thrust Bearings

Blade guard has been removed for

picture clarity. Never operate the bandsaw without

all guards in place and in working order!

Failure to comply may cause serious injury!

1. Disconnect machine from the power source.

2. Blade must already be tensioned and tracking

properly.

3. Loosen thumb screw (F, Fig. 11) and turn knurled

knob (E, Fig. 11) to move the thrust bearing (G,

Fig. 10) in or out until the bearing is 1/64" behind

the blade.

4. Tighten thumb screw (F, Fig. 11).

5. Loosen thumb screw (C, Fig. 11) and turn knurled

knob (D, Fig. 11) to move the guide block bracket

in or out until the front edge of the guide bearings

are just behind the "gullets" of the saw teeth.

6. Tighten thumb screw (C, Fig. 11).

7. Loosen locking bolt (B, Fig. 11) and rotate guide

bearings (A Fig 11) using cam (H, Fig. 11) with

provided 4mm hex wrench as close to the blade as

possible without pinching it.

8. Tighten locking bolt (B, Fig. 11).

Figure 11

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Keine Kommentare

JET 710116K Gebrauchs- und Pflegehandbuch Seite 17