JET 710116K Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 13)

Adjustments

Tilting the Table

Unplug the machine from the power

source before making any repair or adjustment!

Failure to comply may cause serious injury!

Loosen two lock knobs (Fig. 4).

Tilt table up to 45 degrees to the right or down 10

degrees to the left, using the scale mounted to the

trunnion.

Tighten two lock knobs (Fig.4).

Note: Table stop can be removed or further adjusted to

tilt table to the left.

Adjusting 90° Table Stop

Disconnect machine from the

power source.

Loosen lock knobs (Fig. 4) and tilt table left until it rests

against table stop.

Tighten Lock knobs

Use a square placed on the table and against the blade

(Fig. 5) to see if the table is 90 degrees to the blade.

If an adjustment is necessary, loosen lock knobs, tilt

table to the right, and lock in place.

Loosen jam nut and turn table stop (Fig. 4) left or right

to raise or lower the stop. Tighten jam nut to hold table

stop in place.

Unlock table, tilt back onto table rest and confirm table

is 90 degrees with the blade.

If necessary, adjust scale pointer to zero.

Figure 4

Figure 5

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Keine Kommentare

JET 710116K Gebrauchs- und Pflegehandbuch Seite 13