JET 710116K Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 10)

Thread nut on to table stop bolt (Fig. 2) and attach

to trunnion support bracket as shown.

Once table is mounted to the trunnion bracket (see

section below) and the blade is mounted in the

saw (see section “Changing Blades”) you may

choose to fine tune the blade parallel to the miter

slot. Using a square positioned in the miter slot,

loosen screws shown in Figure 2 and lightly tap the

table into position so the blade is parallel with the

miter slot. Then gently tighten down the screws.

This adjustment will ensure square cuts when

using a miter gauge. This adjustment will NOT

correct drift of a blade when ripping with a rip

fence.

Mounting the Table to the

Bandsaw

To mount the table, remove pin and insert from the

table (Fig. 3).

Rotate the table so that the saw blade will slide

through the slot in the table. Then orient the table

so the screws will slide into the holes on the

trunnion support bracket. Attach lock knobs to

these screws (Fig. 3)

Replace pin and insert.

Figure 2

Figure 3

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Keine Kommentare

JET 710116K Gebrauchs- und Pflegehandbuch Seite 10