JET 710116K Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 12)

The 115V attachment plug supplied with the band

saw must be replaced with a UL/CSA listed plug

suitable for 230V operation, as shown in Figure 23.

Contact your local authorized Walter Meier

(Manufacturing) Inc., service center or qualified

electrician for proper procedures to install the plug.

The band saw must comply with all local and

national codes after the 230-volt plug is installed.

The band saw with a 230-volt plug should only be

connected to an outlet having the same

configuration (Figure 23). No adapter is available or

should be used with the 230-volt plug.

Figure 23

Important: In all cases (115 or 230 volts), make

certain the receptacle in question is properly

grounded. If you are not sure, have a registered

electrician check the receptacle.

Extension Cords

Use only three wire extension cords that have three-

prong grounding plugs and three-pole receptacles

that accept the tool’s plug.

Make sure the cord is in good condition, and heavy

enough to carry the current your band saw will draw.

An undersized cord will cause a drop in line voltage,

resulting in loss of power and overheating. Table 1

shows the correct size to use depending on cord

length and the ampere rating on your machine’s

nameplate. If in doubt, use the next heavier gauge.

The smaller the gauge number, the heavier the cord.

Repair or replace a damaged or worn cord

immediately.

Power Extension Cord

Currant

(Amps)

Line

voltage

Cord length in

feet

Cord gaug

(AWG)

0-6 120

0 to 25 18

25 to 50 16

50 to 100 16

over 100 14

6-10 120

0 to 25 18

25 to 50 16

50 to 100 14

over 100 12

10-12 120

0 to 25 16

25 to 50 16

50 to 100 14

over 100 12

12-16 120

0 to 25 14

25 to 50 12

over 50

not recommended

Table 1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

JET 710116K Gebrauchs- und Pflegehandbuch Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge JET 710116K