JET 354169 Gebrauchs- und Pflegehandbuch

Operating Instructions and Parts Manual 17-inch Drill Press Model JDP-17MF WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tenn

10Unpacking Contents of the Shipping Container 1 Head Assembly 1 Table 1 Column and Bracket Assembly 1 Base 1 Owner’s Manual 1 Warranty Registrati

11Assembly 1. Place the base (A, Figure 1) on a level floor. 2. With a 17mm wrench attach the column assembly (B, Figure 1) to the base (A, Figure

1212. Install three down feed handles (B, Figure 4) into the down feed hub (C, Figure 4). 13. Thoroughly clean spindle, arbor and chuck (A/B/C, Figu

13Adjusting the Depth Stop To drill multiple holes at the same preset depth, use the depth stop: 1. Use a pencil to mark the depth the bit will dr

14Return Spring Adjustment The return spring is adjusted at the factory and should not need further adjustment. If adjustment is deemed necessary:

15Basic Operation • Always use a back-up piece of scrap wood to cover the table. This protects both the table and the drill bit. • Place material

16Troubleshooting Trouble Probable Cause Remedy Drill press will not start. Drill press unplugged from wall, or motor. Check all plug connections. F

17Trouble Probable Cause Remedy Excessive drill bit runout or wobble. Bent drill bit Replace drill bit. Worn spindle bearings. Replace spindle bea

18JDP-17MF Drill Press Assembly

19Parts List Index No. Part No. Description Size Qty 1 ... 10600111 ... Base...

2Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Aut

20Index No. Part No. Description Size Qty 68 ... 10706802 ... Retaining Ring ...

21 Index No. Part No. Description Size Qty 701 ... TS-152706 ... Hex Wrench ...

22Electrical Connections WHITEBLACKBLACKWHITEGREENGREENGROUNDJDP-17MF ELECTRICAL SCHEMATIC - 115V 1 3 2 4WHITEBLACKGREENGREENJDP-17MF

23

24 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettoo

3Table of Contents Warranty and Service ...

4 Warning Wear eye protection. Always keep guards in place and in proper operating condition. Do not operate the machine without the guards for any

5• USE RECOMMENDED ACCESSORIES. The use of accessories and attachments not recommended by JET may cause hazards or risk of injury to persons. • N

6Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunctio

7230 Volt Operation If 230V, single phase operation is desired, the following instructions must be followed: 1. Disconnect the machine from the po

8On-Off Switch Padlock To safeguard your machine from unauthorized operation and to avoid accidental starting by young children, the use of a padlo

9Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a JET Model JD